NAD C338

PREAMP High level input, subwoofer output
– Distortion (20Hz – 20kHz):< 0.005% at 2V output – Signal-to-noise ratio:> 106dB (IHF; A-weighted, 500mV output, unity gain)
– Input impedance (R and C): 56kΩ + 100pF
– Maximum input level:> 4.5Vrms (0.1% THD)
– Output impedance: source Z + 200Ω
– Input sensitivity: 50mV (100Hz, 500mV output, volume at maximum
– Maximum output level – IHF load:> 4.5V (0.1% THD)

High level input, headphone output
– Klirrfaktor (20Hz – 20kHz): <0,005% bei 1V Ausgang – Geräuschspannungsabstand: >105dB (IHF; A-gewichtet, 32Ω, 2V Ausgang, Verstärkungsfaktor Eins)
– Frequenzgang: ±0,3dB (20Hz – 20kHz)
– Kanaltrennung: >56dB bei 1kHz
– Ausgangsimpedanz: 0,5Ω

GENERAL High level input, speaker output
– Continuous output power at 4 and 8Ω (stereo): 2x> 50W (at specified distortion factor, 20Hz – 20kHz, both channels driven)
– Pulse power: 2x 80W at 8Ω: 2x 150W at 4Ω; 2x 210W at 2Ω
– Distortion (2Hz – 20kHz):< 0.03% (250mW to 50W, 8 and 4Ω) – Signal-to-noise ratio:> 98dB (A-weighted, 500mV input, 1W output into 8Ω)
– Clipping power:> 60W (at 1kHz and 0.1% THD)
– Maximum output current:> 18A (at 1Ω, 1ms)
– damping factor:> 300 (8Ω, 20Hz to 6.5kHz)
– Frequency response: ±0.3dB (20Hz – 20kHz)
– Channel separation: 1kHz> 75dB; 10kHz> 65dB
– Input sensitivity (for 50W at 8Ω): High level: 380mV, digital input: 18% FS
– Resolution: Up to 24bit/ 192kHz

Phono input, speaker output
– Distortion (20Hz – 20kHz, Stereo):< 0.3% at 50W output – Signal-to-noise ratio:
>82dB (200Ω source, A-weighted, 500mV output)
>76dB (MM cartridge, IHF A-weighted, 500mV output)
– Input sensitivity: 4.1mV (50W, 1kHz at 4Ω output, volume at maximum)
– Frequency response: ±0.3dB (20Hz – 20kHz)
– Input impedance: 47kΩ + 100pF
– Maximum input level:> 80mVrms (0.1% THD)

Power consumption
– in ECO standby mode: 0.4W*
– in control standby mode: 1.8W**
– switched off: 0W
* After 20 minutes of no operation and no input signal
** With Bluetooth wireless connection and 20 minutes without any operation and no input signal
NOTE: The Bluetooth connection can be turned on or off by pressing and holding the PLAY button on the AMP 3 remote control